Lincoln 1/2 zoom_in
Lincoln 1/2" Diaphram Pump
1:1 1/2 " air operating diaphram pump polyprop santoprene 1/2" inlet NPT 1/2" outlet NPT 14 GPM 1/4' air inlet NPT 100 PSI maximum pressure 1/8" particle size used for high abrasion materials

Air-Operated Diaphragm Pumps
1/4" - 2" Air-Operated Pumps

Basic Design Features

Diaphragm pumps are driven by compressed air. The directional air distribution valve and pilot valve—the “air end”—are located in the center section of the pump. Liquid moves through two manifolds and outer chambers of the pump—the “wet end”. Generally, check valves are located at the top and bottom of each outer chamber or on a common manifold. The two outer chambers are connected by suction and discharge manifolds. Lincoln’s double diaphragm self-priming design offers many advances over other pumps.

  • Pump abrasive and sheer-sensitive materials. Low interval velocities move abrasives easily with no damage. Gentle pumping action does not sheer fragile materials.
  • Pumps viscous materials. Even heavy or solids-laden materials can be pumped.
  • Environmentally friendly. No motors, seals or packing to leak.
  • Self-priming. Able to dry prime under most suction lift or flooded suction conditions.
  • Variable flow. Regulate the inlet air supply to adjust flow.
  • Runs dry without damage.
  • Deadheads against closed discharge. Excessive back pressure stops operation without damage until discharge opens. Eliminates bypass systems or relief valves.
  • Explosion-proof. Eliminates sparking concerns of other electrical or rotating pumps.
Model 85630Model 85627Model 85622Model 84811
Model 85630Model 85627Model 85622Model 84811

1:1 Air-operated diaphragm pump line